Can Rate Limit Be Configured on an Eth-Trunk on s5720?

Aasim · Created Aug 14, 2018 09:35:54

You may apply traffic policy to limit the inbound/outbound traffic.

1- Create Traffic Classifier >> i.e Match The VLAN id
2- Create Traffic Behavior >> use the CAR command to limit the traffic using Kbps
3- Create the traffic policy >> Include the created Classifier & behaviour
4- Apply it on the inbound direction of the Trunk

adsasd · Created Aug 2, 2018 20:32:48

This post was last edited by adsasd at 2018-08-02 20:33. Hi Wicam, Do you need something like on the physical interface? <HUAWEI> system-view [HUAWEI] interface gigabitethernet 0/0/1 [HUAWEI-GigabitEthernet0/0/1] negotiation auto [HUAWEI-GigabitEthernet0/0/1] auto speed 100 :)

StarOfWest · Created Aug 8, 2018 07:01:08

it's possible to run the following command on eth-trunk view to configure the maximum rate bandwidth for incoming traffic to 8Mbps. I'm not sure that this is what you are looking for.

qos lr inbound cir 8192 cbs 1024000

Aasim · Created Aug 14, 2018 09:35:54

You may apply traffic policy to limit the inbound/outbound traffic.

1- Create Traffic Classifier >> i.e Match The VLAN id
2- Create Traffic Behavior >> use the CAR command to limit the traffic using Kbps
3- Create the traffic policy >> Include the created Classifier & behaviour
4- Apply it on the inbound direction of the Trunk

Can Rate Limit Be Configured on an Eth-Trunk on s5720?

Recommended answer

Third Party’s Trade Secret

My Followers

Documentation Sharing & Technical Discussion

Enterprise

Consumer

Corporate

Carriers

Can Rate Limit Be Configured on an Eth-Trunk on s5720?

Recommended answer

Third Party’s Trade Secret

My Followers

Documentation Sharing & Technical Discussion