You can use InfoReplicator to configure remote replication tasks
in both the graphical user interface (GUI) and command-line interface (CLI).
Configuring remote replication using the GUI has been described in Configuration and
Management. Table 1 lists the
CLI commands used to configure replication tasks. For details about the usage
of each command, see OceanStor 9000 Command Reference.
|
Table 1 CLI
commands supported by InfoReplicator
|
|
Command
|
Function
|
|
create remote_replication general
|
Creates a replication pair.
|
|
change remote_replication general
|
Modifies a replication pair.
|
|
show remote_replication general
|
Queries a replication pair.
|
|
show remote_replication latest_snap_path
|
Obtains the path to the latest
replication snapshots.
|
|
delete remote_replication general
|
Deletes a replication pair.
|
|
change remote_replication split
|
Splits a replication pair.
|
|
change remote_replication switch
|
Switches the roles of the source and
destination.
|
|
change remote_replication synchronize
|
Starts data synchronization.
|
|
show remote_replication zone
|
Queries a replication zone.
|
|
change remote_replication zone
|
Changes a replication zone.
|
|
clear remote_replication zone_ip_range
|
Clears the IP address segments in a
replication zone.
|
|
clear remote_replication zone_exclude_ip
|
Clears the excluded IP address segments
in a replication zone.
|
|
show remote_replication zone_working_ip
|
Queries available IP addresses in a
replication zone.
|
|
create remote_replication channel
|
Creates a replication channel.
|
|
change remote_replication channel
|
Modifies a replication channel.
|
|
delete remote_replication channel
|
Deletes a replication channel.
|
|
show remote_replication channel
|
Queries a replication channel.
|
|
show remote_replication link_info
|
Queries the link information of a
replication channel.
|
