Cable Connection of eA680 LTE CPE

This section describes the procedure for connecting the eA680 cables.

Step 1: Connect the ground cable, as shown in Figure 1.

                                    Figure1

           
NOTE: Tighten the ground screws and apply antirust paint to it.

Step 2: Install the crystal connector to PoE network cable, as shown in Figure 2.

                                               Figure 2

NOTE: When making PoE network cables, follow the international standard EIA/TIA568A or EIA/TIA568A to arrange the cables. Make sure that the two ends of each network cable use the same standard.

Step 3: Connect the PoE network cable.

   Diassemble the PG-head screw cap and air-proof block on the PoE port, and pass the  network cable through them, as shown in Figure 3.          

                                                                        Figure 3

           Connect the network cable to the network adapter, and manually rotate the screw cap to    ensure that the lock block adheres to the network cable, as shown in Figure 4.                

                                                                              Figure 4

                                                    
Step 4: Connect the PoE adapter.    Connect one end of the PoE network cable to the adapter, as shown in Figure 5.

                                                                        Figure 5

---End    

 You are welcomed to visit our “Enterprise Wireless Information Center” for further document.
http://support.huawei.com/onlinetoolsweb/elte/Info_en.jsp