Bonding on MA5616
- x
- convention：
- Emotion(0)
|
Hi, firend! xdsl bonding-group-profile add This command is used to add a bonding group profile and configure parameters, such as interleave delay, minimum impulse noise protection (INP), upstream and downstream maximum/minimum target rates, upstream and downstream rate monitoring thresholds, rate threshold alarm function, the function of reporting the incorrect CPE in the bonding group, and profile name. To configure such parameters, run this command. Then run the active bonding-group command to bind the profile to a bonding group. After the bonding group is activated, it is configured according to the configured parameters in the profile.
Thanks! |
user_4014635
Created Oct 30, 2020 14:25:49
(0)
(0)
You are the man! thank you so much for the support. See you soon my friend! 
|
|
Chenxintao
Reply user_4014635 Created Oct 30, 2020 14:11:42
(0)
(0)
You can refer to the MA5616 product documentation and knowledge sharing posts on the forum to configure related services.
user_4014635
Reply Chenxintao Created Oct 30, 2020 14:12:35
(0)
(0)
I need to create and assign a bonding-group-profile (I think?), I'm asking you on purpose
Chenxintao
Reply user_4014635 Created Oct 30, 2020 14:12:38
(0)
(0)
Select a specific command based on the service to be configured.
user_4014635
Reply Chenxintao Created Oct 30, 2020 14:14:36
(0)
(0)
I don't have the MA5616 product documentation...
Chenxintao
Reply user_4014635 Created Oct 30, 2020 14:15:04
(0)
(0)
It's hard for me to understand what you're going to configure
user_4014635
Reply Chenxintao Created Oct 30, 2020 14:20:01
(0)
(0)
No, I'm not... so is it too much if i ask you how to create bonding?
Chenxintao
Reply user_4014635 Created Oct 30, 2020 14:23:45
(0)
(0)
Please check my response. My friend! |
|
Hi, firend! xdsl bonding-group-profile add This command is used to add a bonding group profile and configure parameters, such as interleave delay, minimum impulse noise protection (INP), upstream and downstream maximum/minimum target rates, upstream and downstream rate monitoring thresholds, rate threshold alarm function, the function of reporting the incorrect CPE in the bonding group, and profile name. To configure such parameters, run this command. Then run the active bonding-group command to bind the profile to a bonding group. After the bonding group is activated, it is configured according to the configured parameters in the profile.
Thanks! |
user_4014635
Created Oct 30, 2020 14:25:49
(0)
(0)
You are the man! thank you so much for the support. See you soon my friend!
|
Comment
- Politically sensitive content
- Content concerning pornography, gambling, and drug abuse
- Content that may disclose or infringe upon others ' commercial secrets, intellectual properties, including trade marks, copyrights, and patents, and personal privacy
