Bind a VSI to a Qinq Sub-interface and Ethernet Encapsulation

Created: Jun 22, 2018 01:08:25 589 0 0 0

When the VSI is bound to a QinQ sub-interface, the Ethernet encapsulation mode is not supported. There are command line restrictions, which are the same for all versions.

The summary of Handling of VLANs in Packets in Various Versions of L2VPN Configurations .http://forum.huawei.com/enterprise/en/forum.php?mod=viewthread&tid=453137

This post was last edited by Barret at 2018-06-30 03:45.

x
convention：

Helpful (0) Favorite(0) Report

 Previous: Binding a VSI to Qinq Sub-interfaces and VLAN Encapsulation Modes

Next: Binding a VSI to a Dot1q Sub-interface and Ethernet Encapsulation



Comment

Notice: To protect the legitimate rights and interests of you, the community, and third parties, do not release content that may bring legal risks to all parties, including but are not limited to the following:

Politically sensitive content
Content concerning pornography, gambling, and drug abuse
Content that may disclose or infringe upon others ' commercial secrets, intellectual properties, including trade marks, copyrights, and patents, and personal privacy

Do not share your account and password with others. All operations performed using your account will be regarded as your own actions and all consequences arising therefrom will be borne by you. For details, see " Privacy."

My Followers

Are you sure to block this user?
Users on your blacklist cannot comment on your post,cannot mention you, cannot send you private messages.

Please bind your phone number to obtain invitation bonus.

Enterprise

Consumer

Corporate

Carriers

Bind a VSI to a Qinq Sub-interface and Ethernet Encapsulation

Third Party’s Trade Secret

My Followers