AR router vs ppp interface

Unicef · Created Aug 27, 2021 11:58:03

Dear Friend!

MP problems of AR routers can be located based on the following roadmap: 1. MP interfaces transmit data by packets, which cannot be modified. 2. AR routers only support the binding of interfaces of the same card. If the binding cannot be performed on cards equipped with two E1 interfaces, perform it on cards equipped with eight E1 interfaces. 3. Focus on member interfaces when locating MP interface problems because most MP interface problems are caused by the member interfaces. 4. In products with earlier versions, out-of-order problems occur on MP interfaces, which results in the stalling of videos. Use products with V200R0003 and later versions. If the state of the E1 interface of an AR router is not Up, check whether the state of the member E1 interface is not Up. If the E1 interface of an AR router cannot communicate with other devices properly, check whether packet losses occur on the member E1 interface.

THANKS!

Nino_Chou · Created Aug 27, 2021 11:24:11

Hello, friend!
It's nice to meet you in the community.
We're working on getting the right answer for you.

jason_hu · Created Aug 27, 2021 11:30:22

Hi friend!
Since the MAC addresses of the sub-interfaces of the same physical interface of the AR router are the same when dialing through multiple PPPoE-clients bound to the sub-interfaces under the same physical interface. If the PPPoE-server at the opposite end is the same device, the opposite end considers it to be the same dial-up, so only one dial-up connection can go online.
Hope to help you!

Unicef · Created Aug 27, 2021 11:58:03

Dear Friend!

MP problems of AR routers can be located based on the following roadmap: 1. MP interfaces transmit data by packets, which cannot be modified. 2. AR routers only support the binding of interfaces of the same card. If the binding cannot be performed on cards equipped with two E1 interfaces, perform it on cards equipped with eight E1 interfaces. 3. Focus on member interfaces when locating MP interface problems because most MP interface problems are caused by the member interfaces. 4. In products with earlier versions, out-of-order problems occur on MP interfaces, which results in the stalling of videos. Use products with V200R0003 and later versions. If the state of the E1 interface of an AR router is not Up, check whether the state of the member E1 interface is not Up. If the E1 interface of an AR router cannot communicate with other devices properly, check whether packet losses occur on the member E1 interface.

THANKS!

Diego.Silva · Created Aug 27, 2021 13:18:27

Good anwsers!

chenhui · Created Aug 28, 2021 02:51:22

Hello,
I still cannot understand your questions, can you please describe them more detailedly?

S_Noch · Created Nov 2, 2021 04:30:30

cool

AR router vs ppp interface

Recommended answer

Third Party’s Trade Secret

`@trans`bright_future`~trans`

My Followers

Enterprise

Consumer

Corporate

Carriers

AR router vs ppp interface

Recommended answer

Third Party’s Trade Secret

`@trans`bright_future`~trans`

My Followers