AP 5760-10 Model login and configuration

Hi,

please make sure you running the AP in FAT Mode.

if it is FIT AP, chnage to FAT AP.

login to console and run below command,
#ap-switch mode fat
reboot the AP once and it will be running in FAT mode now.

After that follow the below procedure to configure AP:
Before logging in to an AP through the web platform, connect a terminal to the AP using an Ethernet cable or in wireless mode to ensure that they are reachable to each other. Then you can log in to the AP using a browser
SSID: HUAWEI-LeaderAP-XXXX XXXX specifies the last four digits of the AP's MAC address.)
Password: hw_manage
Wired IP: 169.254.1.1
Wireless:192.168.1.1
Username: admin
Password: admin@huawei.com

1. Open the browser on the PC, enter http://IP address or https://IP address in the address box, and press Enter. The login page is displayed.
2. Enter the login information.

a) Select a language.
b) The system supports English and Chinese. By default, the system uses the same language as the browser.
c) Enter a user name and password.
d) Click Login.
e) To ensure security of the web platform, you are prompted to change the password upon the first login, and log in to the web platform again

3. Click Logout in the upper right corner to Log out of the web platform. The login page is displayed.
4. If you do not perform any operation within a specified duration (10 minutes by default), you are logged out. To return to the login page, click OK