Configuring IPv4 FRR

Latest reply: Sep 8, 2018 15:01:30 189 1 1 0

Configuring IPv4 FRR

IPv4 FRR applies to the services that are very sensitive to delay and packet loss on IPv4 networks.

Applicable Environment

If a link failure occurs after FRR is enabled, the fault detection module reports the failure to the upper-layer routing system. The FRR module immediately uses a backup link to forward packets, minimizing the impact of the link failure on services.

icon-notice.gif NOTICE:

IPv4 FRR implements route backup among routes of different routing protocols and may cause routing loops. Therefore, exercise caution when using IPv4 FRR.

Pre-configuration Tasks

Before configuring IPv4 FRR, complete the following task:

  • Configuring link layer protocol parameters and assigning IPv4 addresses to interfaces to ensure that the link layer protocol of the interfaces is Up

  • Configuring IPv4 routes destined for the same destination address but discovered by different routing protocols

Procedure

  1. Run:

    The system view is displayed.

  2. Run:

    IPv4 FRR is enabled.

    By default, IPv4 FRR is disabled.

    icon-note.gif NOTE:

    When FRR is configured in both the system view and the routing protocol view, FRR configured in the routing protocol view is used for route backup.

  3. Run:

    The configuration is committed.

Checking the Configuration

After IPv4 FRR is configured, run the following command to check the configuration.

Run the display ip routing-table verbose command to check detailed information about the backup outbound interfaces and backup next hops of routes in the routing table.

  • x
  • convention:

Sergio93 Created Sep 8, 2018 15:01:30 Helpful(0) Helpful(0)

Thanks, this is helpful.
  • x
  • convention:

BEST ANSWER! If you think I earn it!
If this post was useful to you, please click the Helpful button and flag my post as a "BEST ANSWER" so others can benefit. Thank you

Reply

Reply
You need to log in to reply to the post Login | Register

Notice: To protect the legitimate rights and interests of you, the community, and third parties, do not release content that may bring legal risks to all parties, including but are not limited to the following:
  • Politically sensitive content
  • Content concerning pornography, gambling, and drug abuse
  • Content that may disclose or infringe upon others ' commercial secrets, intellectual properties, including trade marks, copyrights, and patents, and personal privacy
Do not share your account and password with others. All operations performed using your account will be regarded as your own actions and all consequences arising therefrom will be borne by you. For details, see " Privacy."
If the attachment button is not available, update the Adobe Flash Player to the latest version!

Login and enjoy all the member benefits

Login
Fast reply Scroll to top