It’s a simple Lab practice. Just configure two serial ports to make sure the two routers can communicate with each other through serial line.
[RouterA]display interface Serial 2/0/0
Serial2/0/0 current state : UP
Line protocol current state : UP
Last line protocol up time : 2014-10-15 05:50 UTC-05:13
Description:HUAWEI, AR Series, Serial2/0/0 Interface
Route Port,The Maximum Transmit Unit is 1500, Hold timer is 10(sec)
Internet Address is 100.1.1.1/24
Link layer protocol is nonstandard HDLC
Last physical up time : 2014-10-15 05:50 UTC-05:13
Last physical down time : 2014-10-15 05:50 UTC-05:13
Current system time: 2014-10-15 05:50-05:13
Physical layer is synchronous, Virtualbaudrate is 64000 bps
Interface is DTE, Cable type is V11, Clock mode is TC
Last 300 seconds input rate 5 bytes/sec 40 bits/sec 0 packets/sec
Last 300 seconds output rate 2 bytes/sec 16 bits/sec 0 packets/sec
Input: 699 packets, 22418 bytes
Broadcast: 0, Multicast: 0
Errors: 0, Runts: 0
Giants: 0, CRC: 0
Alignments: 0, Overruns: 0
Dribbles: 0, Aborts: 0
No Buffers: 0, Frame Error: 0
Output: 702 packets, 8498 bytes
Total Error: 0, Overruns: 0
Collisions: 0, Deferred: 0
Input bandwidth utilization : 0%
Output bandwidth utilization : 0%
WE only need to remember that if the serial port is DCE, we have to configure clock rate at first. By the way, does anybody know that it's possible to make MTU of ethernet 2000? The config file of eNSP is attached.
