Number of Trunk group exceeds threshold Alarm

To get Circuit condition in Trunk Group:

DSP TGTK:TGN="******"

Such as:

Total Information

-----------------

   Trunk group name  =  ******

        Device type  =  ISUP

               Idle  =  1774(44.00%)

               Busy  =  1927(47.79%)

              Block  =  195(4.84%)

            Unknown  =  0(0.00%)

              Fault  =  6(0.15%)

          Uninstall  =  130(3.22%)

All Circuits Number  =  4032

(Number of results = 1)

To get Office name:

LST TG:TGN="******"

Such as:

Sub-route name  =  ******

   Office name  =  #######-#######

(Number of results = 1)

To get Circuit status or faulty circuits CIC, OPC, DPC, CIC range:

LST OFCTKC:CDT=OFCCIC

To get Circuit status details, each STATE can be selected:

DSP OFTS:STATE=FAULT,ON="######-######";

Such as:

Querying result of module 1000

------------------------------

Trunk group name  =  ******

             CIC  =  3088

     Device type  =  ISUP

   Module Number  =  1000

  Circuit Number  =  4848

  Circuit status  =  Fault

(Number of results = 1)

To get TID number corresponding CIC:

LST OFCTKC:CDT=OFCCIC,QR=LOCAL,ON="######-######",SCIC=XXXX,ECIC=YYYY;

Such as:

Trunk Circuit Basic Information.

--------------------------------

Office direction name  =  ######-######

     Trunk group name  =  *******

    Network indicator  =  National network

                  OPC  =  HXXXXXX

                  DPC  =  HYYYYYY

             MGW name  =  ZZZZZZZ

         Circuit Type  =  ISUP

                  CIC  =  XXXX

                  TID  =  YYYYY

   WCCU module number  =  1023

       Circuit number  =  9157

          Server name  =  LOCAL

 Managed object group  =  PUBLIC

(Number of results = 1)

To check the port status in MGW, open MML command in MGW, then

DSP TIDPORT:TID=******

Such as:

The State Of Port

-----------------

     TID  =  *****

 FrameNo  =  2

  SlotNo  =  12

   OptNo =  1

  PortNo  =  59

   State  =  --------

(Number of results = 1)