Action Group

Configuration

An action group consists of multiple actions. The actions are logically divided into different groups to facilitate management.

When an event defined by the trigger occurs, all the rules triggered by the event are enforced according to their priorities. In this case, the UPCC sends the actions contained in an action group under the dynamic rules to the PCEF. Therefore, you must specify an action group when configuring a dynamic rule.

To add an action group, perform the following steps:

1. In the navigation tree, choose Policy Management > Policy > Action Group. The action group query page is displayed.
2. Click Add. The Add Action Group dialog box is displayed.
3. Set basic information about the action group on the Basic Information tab page, as shown in Figure 1. For details about the parameters, see Table 1.
   Figure 1 Setting basic information about the action group
   http://localhost:7904/pages/CEC1230A/01/CEC1230A/01/resources/upcc/reference/gui/pms/figure/fig_cn_90_29_pms007_01.png