Home/Groups/Core Network Info Community

Configuring RAID 1 for a Board UPCC

abrahim Diamond Medal

Medal

(1)
7 years 10 months ago View: 1103 Reply: 4

1F
View The Author

Configuring RAID 1 for a Board

Scenarios

When installing software on a new board or reinstalling software on a board after replacement of hard disks, check whether RAID 1 is correctly configured on the board.
If two hard disks, which are configured with RAID 1, have been replaced, you need to delete the existing RAID 1 configuration and then configure RAID 1 again.

Impact on the System

This operation has no adverse impact on the system.

Prerequisites

Conditions

There are no special conditions for this operation.

Data

Data preparation is not required for this operation.

Procedure

Check the RAID 1 configuration of the specified board.

Log in to the GUI of the board through KVM over IP. For details, see KVM over IP Operations.
Log in to the client and run RST BRD in the MML Command - CGP window to restart the board

Favorite

Favorite (0) | Like |Report

Armetta Diamond
7 years 10 months ago

2F
View The Author

This document is very well done

benjamin.omeke Diamond
7 years 10 months ago

3F
View The Author

thanks for sharing.

Alaul Diamond
7 years 10 months ago

4F
View The Author

Yes this is very useful thanks

user_2837311 Diamond
3 years 10 months ago

5F
View The Author

useful post, thanks