Great! You have got 20 points on this task. We have put your points on record. Thanks for your participation

Hi Wangdi,  thank you for your feedback. We have checked the command-finder. Does the command-finder work now? 

Hi Wangdi,  thank you for your feedback. We have checked the command-finder. Does the command-finder work now? 

d00136529 Posted on 2014-09-15 16:28

Its working Thanks ............  

Thanks for support ..........

1. Screen shot;

 

2. Three frequently used commands:

- acl

-permit

-deny

1. Display pdpcontext msisdn 88017xxxxxx(to see the pdp context in ggsn of a subscriber). 2.Dsp userinfo/useralldata(to see the vlr information and location information of a subscriber). 3. Lst dynsub (to see the dynamic information in hlr)

Hi karma.deker,

You have got 20 points on this task. We have put your points on record. Thanks for your participation

Hi, kaushik.ahmed

 You have got 10 points on this task. Thanks for your participation

  If you post a screenshot of the command finder, you would get another 10 points

1. display sysman ip-access protocol-type

2. display traffic table ip

3. display acm-clock-ip

3 Frequently Used Commands for Datacom:

1. display IP routing table

2. Display Eth-Trunk  "trunk number"

3. display VLAN " VLAN number

On NE40E

Most frequently used commands - 

- display history-command

- source-port

- tracert