In normal cases, the CG9812 boards are installed in the subrack from right to left in turn. The two board configurations in common use are as follows:

• Figure 1 shows the board configuration for the CG9812 boards in a subrack.
• Figure 2 shows the board configuration for the CG9812 and OMS2600 boards in the same subrack.

http://localhost:7904/pages/31184372/01%20%282010-03-10%29/31184372/01%20%282010-03-10%29/resources/public_sys-resources/icon-note.gif NOTE:

You should configure the CG9812 boards based on the actual conditions.

Figure 1 Board configuration for the CG9812 boards in a subrack
http://localhost:7904/pages/31184372/01%20%282010-03-10%29/31184372/01%20%282010-03-10%29/resources/cnup/installation/hard_inst/figure/cn_26_10_0000101.png

Figure 2 Board configuration for the CG9812 and OMS2600 boards in the same subrack
http://localhost:7904/pages/31184372/01%20%282010-03-10%29/31184372/01%20%282010-03-10%29/resources/cnup/installation/hard_inst/figure/cn_26_10_0000102.png

This is very useful and related to my job