My query was: How do I change the access-side signaling address in a proxy mapping group of the SE2600?

But i could not get ans from anyone, then i am looking into Huawei HedEx file where i am finding the below solution which solved my problem.

>>Run the display sbc mapgroup proxy mapgroup-index command to check whether the proxy mapping group is enabled.

• In the view of a disabled proxy mapping group (The keyword enable is not available in the output of the display sbc mapgroup proxy command.)

  1. Run the undo clientaddr command to delete an access-side signaling address.

  2. Run the clientaddr ip-address command to reconfigure an access-side signaling address.

• In the view of an enabled proxy mapping group (The keyword enable is available in the output of the display sbc mapgroup proxy command.)

  1. Run the undo enable command to disable the proxy mapping group.

  2. Run the undo clientaddr command to delete an access-side signaling address.

  3. Run the clientaddr ip-address command to reconfigure an access-side signaling address.

When a proxy mapping group is enabled, changing an access-side signaling address in the mapping group has an adverse impact on the services that are accessed through this IP address. Therefore, exercise caution while changing an access-side signaling address in an enabled proxy mapping group.

Thanks

You have a great success story keep it up ............

very good success...