Sometimes I have experienced that when a large amount of NEs depends from one GNE the SCC hang up the communication channel. To restore this problem you just need to perform a warm reset of the SCC board, but some time later the same issue will appear, so it?s better if you redistribute the amount of NEs to depend of diferent GNEs. It?s recommended to avoid have more than 50 NEs depending from the same GNE.

normally alarm DCN_Size_Over should be raised when  there is huge entries (100) on routing table of GNE

Be careful if you have RTN microwave series connected with OSN series, and ECC established on these links, you will have ECC loop and ECC storm and loss of supervision

ECC must be disabled on RTN to OSN links if one of the two have already access to more than one GNE

normally alarm DCN_Size_Over should be raised when  there is huge entries (100) on routing table of GNE

Be careful if you have RTN microwave series connected with OSN series, and ECC established on these links, you will have ECC loop and ECC storm and loss of supervision

ECC must be disabled on RTN to OSN links if one of the two have already access to more than one GNE

saad_soufi Posted on 2014-06-05 22:53

Thank you for your more sharing, it is useful!

thanks for share

good. thanks

Good idea! thanks