Hello all,

We are using almost 600 NE40E series routers (NE40E-4, NE40E-X3, NE40E-X8) in our network.

Our version is V6R7SPC300 and we are planning to upgrade it V600R009C20SPC600.

My question/suggestion is about VSIs.

When we wanna change something on a predefined VSI, firstly i have to use "display vsi" command to learn its name.

And then i can detemine the VSI which i would use.

But, i should do like below;

1- Type "system-view" 

2- Type "vsi" and then press "TAB" button and list whole VSIs which defined on router.

<NE40E>system-view

[NE40E]vsi "TAB"

vsi1

vsi2

vsi3

vsi4

What do you think about this?

TAB is used for add command, for see all vsi you can do
display current | i vsi
or

dis current-configuration filter vsi <-- for filtring vsi with vsi-id

Posted by m7g at 2017-08-14 13:40 TAB is used for add command, for see all vsi you can dodisplay current | i vsiordis current-configur ...

Thanks for your advice but they are not useful..

If you need to change some parameter at a VSI, you should not list all VSIs..

You should directly type;

system-view
vsi <TAB>

and then see whole VSIs..

Otherwise;

1- List whole VSIs
2- copy VSI name which you need
3- system-view
4- vsi "your vsi"

Posted by oktay.tatar at 2017-08-18 12:32 Thanks for your advice but they are not useful..If you need to change some parameter at a VSI, you ...

Why ? )

1. list whole VSIs - "display current | i vsi" or "display vsi" work at all version.

In my version (V600R008C10SCP300) did not work:
- system-view
- vsi <TAB> - for list all vsi...

"display current | i vsi" is not useful..

Because you need to list all VSIs before you configure a preconfigured vsi everytime..

But we can directly configure with TAB button..

We typed "system-view" and then "vsi" and then press TAB and will be listed whole VSIs..

But Huawei VRP do not support this function..