After services are switched from the active system control board to the standby system control board on the OptiX RTN 950/980 NE, the queried working state of the clock is different from the actual working state of the clock on the NE. Is there have any reason/ is it software bug??

This thread is a good source of knowledge, clock synchronization is very very important for SDH system.

good question

In general it is 3-5 secs, some times it may vary depends upon version

Posted by Debobroto at 2016-08-26 19:48 Dear, Is there any relationship between the LTI and SYNC_C_LOS alarms? ...Thanks in advance

Default mode is always set at 2400 hrs

excellent qus