Why does an AC fail to detect unauthorized APs after calibration is enabled

Perform the following operations to locate the fault:

1. Check whether unauthorized AP detection is enabled when calibration is enabled on the AC.

2. Check whether neighbor detection is enabled for the AP.

Perform the following operations on the AC:

1. After the calibration command is executed, check whether the AC sends a neighbor detection message to the AP.

2. Check whether the AP receives the neighbor detection message from the AC.

3. Check whether the AP reports detected neighbor information to the AC.

4. Check whether the AC receives neighbor information sent from the AP.

5. Check whether errors occur when the AC is saving received neighbor information.

Scroll to top