How do I locate VAP creation failures

To locate VAP creation failure on a WLAN device, perform the following steps:
For an AC:
V200R005 and earlier
1. Check whether the AP exists.
2. Check whether the VAPs of the AP are fully configured.
3. Check whether the radio interface is bound to a radio profile.
4. Check whether the service set is configured correctly and bound to the radio interface.
5. Check whether the configuration is committed.
6. Check whether the AP works properly and whether the configuration is delivered successfully.
V200R006 and later
1. Check whether the AP exists.
2. Check whether the VAPs of the AP are fully configured.
3. Check whether the radio interface is bound to a radio profile.
4. Check whether the VAP profile is configured correctly and bound to the AP or an AP group.
5. Check whether the AP works properly and whether the configuration is delivered successfully.
For a Fat AP:
1. Check whether the VAPs of the AP are fully configured.
2. Check whether the radio interface is bound to a radio profile.
3. Check whether the service set is configured correctly and bound to the radio interface.
For an S series switch serving as the AC
1. Check whether the AP exists.
2. Check whether the VAPs of the AP are fully configured.
3. Check whether the radio interface is bound to a radio profile.
4. Check whether the service set is configured correctly and bound to the radio interface.
5. Check whether the configuration is committed.
6. Check whether the AP works properly and whether the configuration is delivered successfully.

Scroll to top