BOM code descriptions of copper fittings of DPD63-8-8 PDUs

Question:
What are the BOM codes of copper fittings of DPD63-8-8 PDUs?
Answer:
1. Case TC0001723534 describes the BOM codes of the copper fittings. This case elaborates the BOM codes for deployment reference.
2. The cause why copper fittings are required is as follows:
The DPD63-8-8 PDU is used as an example. The PDU supports only 8 x 63 A current inputs, and therefore cannot be directly used in a scenario when fewer than 8 channels of current inputs are available or other scenarios. Then a copper fitting is required to short-circuit multiple input terminals in these scenarios.
3. Two-in-one copper fitting (BOM code: 21170260):
It must be installed in the DPD63-8-8 PDU. It applies to scenarios in which one channel of power supply is divided into two channels. For example, when 8 x 63 A inputs are required but only 4 x 100 A inputs are available, you can use this two-in-one copper fitting for short-circuiting before connecting to the power supply. During installation, note that it includes two pairs of copper bars, one pair on the left and one pair on the right. It supports a 63 A circuit breaker.
Two-in-one copper fitting (without BOM code):
It is delivered with the PDU and does not need to be configured. It is installed on the positive pole (a black power cable), and works with the copper fitting (BOM code: 21170260). It is delivered in the accessories package of a cabinet. Keep it safe.
Four-in-one copper fitting (BOM code: 21170262):
It must be installed in the DPD63-8-8 PDU. It applies to scenarios in which one channel of power supply is divided into four channels. For example, when the cabinet uses only boards of low power consumption and a single channel of 100 A input is enough, you can use this four-in-one copper for short-circuiting before connecting to the power supply. Note that this copper fitting only applies to a scenario in which the input current is below 120 A, and each circuit breaker cannot exceed 32 A.
Four-in-one copper fitting (BOM code: 21170324)
It must be installed in the DPD63-8-8 PDU. It is installed on the positive pole (a black power cable) and works with a four-in-one copper fitting (BOM code: 21170262).

Scroll to top