Modify the slot ID of a member switch in a stack of S series fixed switches

To modify the slot ID of a member switch in a stack of S series fixed switches, run the stack slot old-slot-id renumber new-slot-id command. The modification takes effect only after the switch restarts. When the new slot ID takes effect, the slot ID of interfaces on the switch also changes to the new slot ID.
The slot ID of a switch may change when the switch belongs to a stack or the switch fails to be upgraded. You can use the following methods to change the slot ID of a switch to 0 (default value). For example, change 2/0/1 to 0/0/1. Then restart the switch to make the resetting take effect.
�?(Stack card connection mode) Run the undo stack enable command in the system view to disable the stack function.
�?(Service port connection mode) Run the undo stack enable command in the system view to disable the stack function.
�?To specify a new slot ID again, run the stack unit-id 2 renumber 0 command in the system view.

Scroll to top