Split stacks of S series fixed switches

Split a stack of S series fixed switches that is established in stack card connection mode as follows:
1. Run the save command to save the configuration.
2. Run the copy source-filename destination-filename all command to back up the configuration file to all the member switches.
3. Remove stack cables between the member switches. After the stack cables are disconnected, the stack splits. Part of the member switches restart. Remote login may fail because configurations such as the IP address of the stack member switches are the same. Log in to a switch through the console port and perform the following operations.
4. Run the system-view command to enter the system view.
5. Run the stack slot slot-id renumber 0 command to restore the stack ID of the member switch to the default value 0.
6. Power off all the member switches.
7. Remove the stack card.

Split a stack of S series fixed switches that is established in service port connection mode as follows:
1. Run the save command to save the configuration.
2. Run the copy source-filename destination-filename all command to back up the configuration file to all the member switches.
3. Remove stack cables between the member switches. After the stack cables are disconnected, the stack splits. Part of the member switches restart. Remote login may fail because configurations such as the IP address of the stack member switches are the same. Log in to a switch through the console port and perform the following operations.
4. Run the system-view command to enter the system view.
5. Run the interface stack-port member-id/port-id command to enter the logical stack port view.
6. Run the shutdown interface { interface-type interface-number1 [ to interface-type interface-number2 ] } &<1-10> command to disable the physical member port.
7. Run the undo port interface { interface-type interface-number1 [ to interface-type interface-number2 ] } &<1-10> enable command to restore the physical member port to a service port.
8. Run the quit command to exit from the logical stack port.
9. Run the stack slot slot-id renumber 0 command to restore the stack ID of the member switch to the default value 0.
10. Power off all the member switches.

Note: Steps 5 to 7 are performed to restore a stack port to a service port, and the operations are performed based on versions later than V200R002. For details about configuration in V200R002 and earlier versions

Scroll to top