Method used to output logs of the USG2000, USG5000, or USG6000 to the control console

Method used to output logs of the USG2000, USG5000, or USG6000 to the control console

This configuration can enable the system to output debugging information to the control console.

Context
The system outputs debugging information to the control console using console information channel 0. The debugging information switch is set to On, and the verification level is set to debugging.

Procedure:
Configure the channel for outputting debugging information.
On the device where the configuration information center resides, run the system-view command to enter the system view.
Run the info-center source { module-name | default } channel { channel-number | channel-name } [ debug { state { off | on } | level severity } * ] command to add debugging information to the information channel.

The system can output debugging information only when the information center is enabled. By default, the timestamp of the debugging information is in the boot format.


Configure the system to output debugging information to the control console as follows:
On the device where the configuration information center resides, run the system-view command to enter the system view.
Run the info-center console channel { channel-number | channel-name } command to configure the system to output information to the CON control console.
Configure the terminal display function:
On the device where the configuration information center resides, run the terminal monitor command to enable the information display function of the terminal. By default, this function is enabled. The preceding command is valid only to the current terminal.
Run the terminal debugging command to enable the terminal to display debugging information.
Example
In the system view, run the info-center source default channel 0 command to add debugging information to information channel 10.

For [USG] info-center source default channel 0, run the info-center console channel 0 command to configure the system to output debugging information to CON0 control console.

[USG] info-center console channel 0

Scroll to top