Method used to input logs of the USG2000, USG5000, and USG6000 to the log server

The method used to input logs of the USG2000, USG5000, and USG6000 to the log server is as follows:


1. Run the system-view command to enter the system view.
2. (Optional) Run the info-center source { module-name | default } channel { channel-number | channel-name } [ log { state { on | off } | level severity }* ] command to add logs to the information channel.

By default, the system outputs logs to the log server using information channel 2. The log switch is set to on and the severity is set to informational. You only need to configure this command when you modify the default system configuration.

3. Configure the module-name to set the module that outputs logs.

4. Configure the severity to set the severity of output logs.


5. Bind the information channel with the log server, so that logs can be output to the log server over this channel.
6. Configure the IP address and parameters of the log server.

info-center loghost ip-address [ port ] [ module { module-name } &<1-6> ]
info-center loghost ip-address [ port ] [ channel { channel-number | channel-name } | facility local-number | language { chinese | english } ]*
The channel-number or channel-name must be consistent with that configured in 1.


7. (Optional) Run the info-center loghost source ip-address command to specify the IP address that sends logs.

Scroll to top