Full disk scanning for hard disks of the USG6000 series

Disks may be bumped during delivery, which may cause disk failures. Before usage, you can perform full disk scanning to repair the disks. Full disk scanning takes 2 to 3 hours.
Note: Hard disk self-check interrupts hard disk services. Exercise caution when you perform full disk scanning.
1. Install the hard disk to the device.
2. In the system view, run the disk offline command to enable the hard disk to go offline.
3. In the diagnose view, run the disk self-test enable command to perform full disk scanning.
4. In the diagnose view, run the display disk self-test command to view the result of disk self-check.
Progress: displays the progress. For example, in 2/46, 46 indicates that the operation may take 46 minutes, and 2 indicates that 2 minutes have elapsed. The actual time taken shall no longer than 46 minutes. Otherwise, the disk is faulty.
ErrorType:
Selftest complete without error: indicates that the hard disk is not faulty.
Send command failed!: indicates that you shall run the self-check command again.
Other: indicates that the hard disk is faulty, and you need to replace it or contact professionals for analysis.
DiskSN: indicates the SN of the current hard disk. The self-check result corresponds to the SN.

Other related questions:
Steps for scanning VM hard disks
If you have more questions, you can seek help from following ways:
To iKnow To Live Chat To Google
Scroll to top