Method used to configure UltraPath in the cluster environment

You can configure UltraPath in the cluster environment as follows:
After you install the UltraPath software in the cluster environment, perform the following configurations:
1. Enable the cluster function.
If you are to install UltraPath of the V100R002 version, manually enable the cluster function. If you are to install UltraPath of the V100R003 or V100R005 version, the system automatically enables the cluster function after installing the UltraPath software successfully.
Note:
The following operations are performed on in the Windows operating system. For details about UltraPath configuration in other operating systems, see the OceanStor UltraPath for XX User Guide. (XX is a specific operating system.)
a. On the UltraPath for Windows Manager home page, click the Configuration tab.
b. In the Cluster area, select Cluster Enable.
c. Click Apply.
2. Set the Persistent Reversed Key (PRKey) of UltraPath to different values.
The PRKey value is 00000101 by default. The first six digits from the left 000001 represent a cluster, and the remaining two digits 01 represent a node. Different nodes require different PRKey values. For example, in a dual-node cluster, if the primary node's PRKey value is 00000101 and the secondary node's PRKey value can be 00000102.
a. On the UltraPath for Windows Manager main interface, click the Configuration tab.
b. In the Persistent Reservation Key area under Cluster, enter different PRKey values.
c. Click Apply.

Scroll to top